EBC S10 Brake Pad and Rotor Kit Engine Components>Main Stud & Bolt Kits

EBC S10 Brake Pad and Rotor Kit Engine Components>Main Stud & Bolt KitsDO NOT FIT UPGRADE PADS TO REAR OF VEHICLE UNLESS SAME UPGRADE FITTED TO FRONT, The Thermic Black coating? does NOT need to be removed before install. Do NOT use brake cleaner or any other method to remove Thermic Black coating from discs rotors. The Thermic black coating will be removed in the pad swept area by the brake pads with in the first 10 to 20 stops made after installation on the vehicle. The Thermic Black coating? is an anti corrosion

The HPCP3 pump replaces the existing injection pump and simply bolts in place to produce up to 5

Easy-to-clean filter

these Smoked Tail Lights will make an impactful statement to the exterior appearance of your Jeep

all necessary hardware including under chassis brace spacers and hardware

with the ability to go from super soft up to a stiff performance setup

The Lc-2S Self-Calibrating Circuitry Also Compensates For Changes In Temperature

1/8 NPT compression fitting

The microphone and cable are hooked out of the way

This arm can be used on vehicles with stock ride height or vehicles that have been altered for performance

Aeromotive fuel system

Key Features: The 4-Ch Analog Module

Direct fit replacements for your factory fog lights