Heavy Duty Camera Clamp for VBOX HD2 38 Way Connector

Heavy Duty Camera Clamp for VBOX HD2 38 Way ConnectorThis heavy duty aluminum camera clamp is designed for the VBOX Video HD2 camera. Using two M3 hex screws and a rubber liner for extra protection, this upgraded clamp prevents the camera from moving from its desired position over time with on track use and ensures the camera remains intact even when fully tightened. The clamp can be attached to either the VBOX Roll Cage Camera Mount (RLACS286) or the Suction Cup Camera Mount (RLACS287). Only the clamp

400 75 163 5

o Weight: ≈14g

Bosch Part Number: F02U V00 111-05

The high resolution bullet camera is a sealed IP67 rated unit

and will start monitoring these

• Power consumption 70 mA typical

for measuring ignition timing

The main benefit of the sensor is the combination of a high-quality production part and a robust and compact design

- Enables conversion to 2 pedal car set up

roll rate)

Stack’s iconic pre-configured dash displays have been trusted by racers for decades to monitor the most critical racing engine parameters

Speed signal capability on all inputs